Changes between Version 16 and Version 17 of Manual

Timestamp:

05/28/2018 02:07:20 PM (6 years ago)

Author:

thomas

Comment:

--

Manual

@@ -23 +23 @@
 Make sure that the debug console window is in focus and then press `r`. Then `Buchla 700 BIOS / Debug PROM` should appear and there should be a `ROMP:` prompt. You are now talking to the 700's built-in debug monitor via one of the 700's serial ports.
 
-Now, in the debug monitor, type `midas` and press `Enter`. This will load the MIDAS operating system from the floppy disk image, `buchla.disk`, which came in the ZIP archive with the emulator. This will take a while - floppy drives were slow! Once MIDAS has been loaded, you'll get another `ROMP:` prompt. Now type `go $10000` actually run MIDAS. The external monitor should now show a menu and the LCD display should show faders.
+Now, in the debug monitor, type `midas` and press `Enter`. This will load the MIDAS operating system from the floppy disk image, `buchla.disk`, which came in the ZIP archive with the emulator. This will take a while - floppy drives were slow! Once MIDAS has been loaded, you'll get another `ROMP:` prompt. Now type `go $10000` to actually run MIDAS. The external monitor should now show a menu and the LCD display should show faders.
 
 You can exit the emulator at any time by pushing the `Esc` key.